Phono Preamps - Why can’t I just use a good mic pre?

Author Topic: Phono Preamps - Why can’t I just use a good mic pre?  (Read 4566 times)

admin

  • Administrator
  • Newbie
  • *****
  • Posts: 37
    • View Profile
Phono Preamps - Why can’t I just use a good mic pre?
« on: September 29, 2015, 06:48:33 pm »
“Why can’t I just use a good mic pre?” you might ask. Well, a little history is in order.

In the golden era of recording, grooves were cut into a disc by a lathe. The grooves physically represented the waveform that was recorded.

Playback is achieved by having a needle (connected to a magnetic pickup) riding in the groove. The side-to-side variations of the groove move the needle and magnetic pickup. The electrical output from the pickup is our audio signal, just waiting to be amplified.

To get a certain amount of time on a 12" disc that is spinning at 33-1/3 RPM, the grooves could only be cut so big. If you varied the groove too much it would cut over into an adjacent groove, destroying it. This is where mastering engineers really earned their pay!

There was still one problem to overcome. As frequency increases, the amplitude of the waveform required to reproduce the same sound level drops. Therefore, low frequencies need a bigger groove than high frequencies. That also means that high frequencies would get lost in the noise floor as their groove size got smaller.

To overcome this effect, pre-emphasis, an equalization curve, was applied to the signal. This artificially increased the size of the higher frequency wiggles in the record to keep them detectable above the noise floor. To recover the audio properly, the preamp used on the magnetic pickup must “de-emphasize” the boost in the highs.

The specification for the de-emphasis is that the frequency response should start to fall off between 50 Hz and 500 Hz and then again around 2.1 kHz. The actual specificatio ns are in time constants (obtained by multiplying the appropriate resistance and capacitance) and are 3180, 318, and 75 microseconds

MIX278 Joseph Phono Pre-amp
Description

    Allows turntables or microphones to be used with any amplifier
    Adds phono input and microphone input to amplifier
    Suitable for stereo mic or 2 mono mics
    IC Technology for high gain and low noise
    Sturdy anti-hum metal casing

Specifications

    Input impedance 50kOhms
    Input level 0.5dB mic mode / 34dB phono mode
    Gain 50dB mic mode / 34dB phono mode
    Signal to noise >48dB mic model / >55dB phono mode
    Freq response (mic mode) + 1dB to -3dB 70Hz - 20KHz
    Equalisation (phono mode) RIAA  + 1dB to - 3dB 30Hz - 20KHz
    Out put level 150mV RMS
    Load impedance >10kOhms
    Overload margin 23dB
    Crosstalk 55dB
    Supply voltage 12-15v DC/ 100mA
    1.3mm DC socket (centre + ve)
« Last Edit: September 29, 2015, 06:51:35 pm by admin »